Flat & Low-Slope Roof Installation
Complete TPO, EPDM and SBS roof systems for Alberta businesses.
Care in Every Layer. Confidence in Your Roof.
A commercial roof is a working system over people, stock and equipment. At Nova Clad, we plan the project around your operations, explain your membrane options, and keep you informed from tear-off to final report.
Quality Materials for Your Building
- TPO, EPDM and SBS modified-bitumen membranes.
- Polyiso insulation and coverboard for a solid, energy-efficient base.
- Metal flashings, drains, scuppers and termination bars.
- Compatible adhesives, sealants and fasteners for every detail.
Roof Preparation
- Remove existing roofing or assess for an approved re-cover.
- Inspect the deck and repair deteriorated areas before installation.
- Stage materials and protect building access, HVAC and landscaping.
We review deck repairs and any re-cover options with you before proceeding.
Insulation & Coverboard
- Install insulation to the specified R-value, staggered and fastened to spec.
- Tapered systems and crickets that direct water to the drains.
- Coverboard for impact and hail resistance where specified.
Drains, Edges & Flashings
- Flash drains, scuppers and overflow outlets watertight.
- Metal edge and parapet details to resist wind uplift.
- Protect roof-to-wall transitions and expansion joints.
Watertight Seams & Terminations
- Heat-weld or seal every seam to manufacturer requirements.
- Probe and test seams before sign-off.
- Secure terminations at walls, curbs and penetrations.
Rooftop Units & Penetrations
- Flash HVAC curbs, vents, gas lines and conduit penetrations.
- Coordinate with your mechanical contractor where needed.
- Walkway pads to protect service routes.
Finishing With Care
- Final inspection of membrane, seams and flashing details.
- Remove debris and magnet-sweep the grounds.
- Walk through the completed work with a photo report.
Our commitment: Careful workmanship, clear communication and installation guided by applicable Alberta building-code requirements and manufacturer instructions.
